TOS SN63BX4000 MANUAL LATHE (USED) REGROUND BED – AS NEW ACCURACY

TOS SN63BX4000 MANUAL LATHE (USED) REGROUND BED – AS NEW ACCURACY

SPECIFICATIONS:

WORKING CAPACITY

• SWING OVER BED 80”
• SWING OVER CROSS SLIDE             38”
• SWING IN GAP             64”
• DISTANCE BETWEEN CENTERS (4000 MM)             48”
• MAXIMUM WEIGHT OF WORKPIECE             3306 lbs
• WIDTH OF GAP IN FRONT OF FACEPLATE             81”
• WIDTH OF BED 71”
• MAIN MOTOR             15 HP

SPINDLE

• BORE 79”
• SPEEDS – NUMBER 16
• SPEEDS – RANGE I 10-112 RPM
• SPEEDS RANGE II 90-1000 RPM
• TAPER             METRIC 80

CARRIAGE

• NUMBER OF LONGITUDINAL AND CROSS FEEDS             38
• LONGITUDINAL FEEDS             002-0.242”/REV
• CROSS FEEDS             001-0.12”/REV
• THREAD – 29 METRIC             05-40 MM
• THREAD – 35 WHITWORTH             1-80 TPI
• LEADSCREW – DIAMETER             89”
• LEADSCREW – PITCH             1/4″
• RAPID TRAVERSE – CROSS (PER MINUTE)             05”
• RAPID TRAVERSE – LONGITUDINAL (PER MINUTE)             11”

TAILSTOCK

• DIAMETER OF BARREL             54”
• TAPER             MORSE #5
• TRAVEL OF BARREL             44”

STANDARD EQUIPMENT:

• 1 – STANDARD STEADY REST
• 1 – NEW 40 POSITION QUICK CHANGE TOOLPOST & 4 HOLDERS
• 1 – NEW D1-8 3 JAW CHUCK PRICE INCLUDED WITH MACHINE AT NO EXTRA COST
• NEWALL DIGITAL READOUT

STANDARD FEATURES: *REGROUND

• GRINDING OF CARRIAGE, TAILSTOCK AND GIB WAY SURFACES OF THE LATHE BED.
• GRINDING OF CROSSLIDE AND TOPSLIDE SURFACES (INCLUDING DOVETAILS).
• MILLING AND INSERTING TURCITE ON UNDERSIDE OF CARRIAGE.
• GRINDING UNDERSIDE OF TAILSTOCK AND SHIMMING TO BRING ON CENTER WITH HEADSTOCK.
• COMPLETE DISASSEMBLE AND REASSEMBLY OF MACHINE INCLUDING REALIGNMENT OF HEADSTOCK.
• GRINDING AND FITTING OF ALL GIBS RELATIVE TO CROSSLIDE AND CARRIAGE.
• REFITTING OF CROSSLIDE SCREW AND NUT.
• CHANGING OF OIL IN HEADSTOCK, GEARBOX AND APRON.
• A GENERAL CLEANING INSPECTION OF MACHINE.
• IN INCH PERFORMANCE WITH STANDARD EQUIPMENT AND OPERATING ON 440/3/60 ELECTRICAL SUPPLY

NEW PARTS INSTALLED:

• NEW BEARINGS IN CARRIAGE APRON
• NEW ½” NUTS
• NEW LEAD SCREW SUPPORT BUSHING
• NEW HEX FEED DRIVE BUSHING
• NEW CROSSFEED SCREW AND NUT
• NEW 16” 3 JAW TOS CHUCK D1-8 CAMLOCK
• C/W COOLANT TRAY AND COOLANT TANK AND PUMP SUPPLIED WITH MACHINE